The Highsider Apollo LED Turn Signal is suitable for mounting, fitting or molding into the desired fitment.

It features a black aluminum housing with smoked lenses and an 8mm mounting stud.

With this innovative lighting technology, two bright SMD LEDs are installed in the center, enabling an extremely small design.

The outer ring consists of COB technology (Chip On Board).

Thanks to the new LED chip embedding for high-power LEDs, a very high luminance can be achieved with the best possible efficiency and service life.

This also allows higher light values to be achieved than with conventional LED lights.

This module comes with a black anodized aluminum ring that fits over the base body.

Sold in pairs

• Connections:
• Black wire = ground (-)
• Yellow wire = turn signal (+)

NOTE: The unit can be installed flat without the aluminum ring, leaving only the lens visible. This requires drilling a 20mm wide hole. Alternatively, the unit can be mounted with the aluminum ring on e.g. a retaining plate on the vehicle.